Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 183 (WIPERS/WASHERS)
2002 Honda Civic Si
Section 183 (Wipers/Washers)
2002 Honda Civic SiSECTION Section 183 (Wipers/Washers)
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
- Component Location Index
- Circuit Diagram - Windshield
- Circuit Diagram - Rear Window
- DTC
- DTC Troubleshooting
- DTC B1028: Rear Window Wiper Motor (As) Signal Error
- DTC B1076: Windshield Wiper Signal Error
- DTC B1077: Windshield Wiper (As) Signal Error
- DTC B1281: Windshield Wiper Switch MIST Position Circuit Malfunction
- DTC B1282: Windshield Wiper Switch INT (AUTO) Position Circuit Malfunction
- DTC B1283: Windshield Wiper Switch LOW Position Circuit Malfunction
- DTC B1284: Windshield Wiper Switch HIGH Position Circuit Malfunction
- Wiper/Washer Switch (Combination Switch Control Unit) Input Test
- Wiper/Washer Switch Replacement
- Wiper Motor Test
- Washer Motor Test
- Washer Fluid Level Switch Test
- Wiper Motor Replacement
- Rear Window Wiper Motor Replacement
- Washer Reservoir Replacement
- Washer Tube Replacement
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.