SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 181 (INTERIOR LIGHTS)INTERIOR LIGHT SWITCH TEST/REPLACEMENT
2002 Honda Civic Si

Interior Light Switch Test/Replacement

2002 Honda Civic SiSECTION Interior Light Switch Test/Replacement
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center panel (see DASHBOARD CENTER PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 6P connector (A) from the interior light switch (B).
    Fig 1: Disconnecting 6P Connector From Interior Light Switch
    G03706723Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the screws and the switch.
  4. Check for continuity between the terminals in each switch position according to the table shown in Fig 2 .
    Fig 2: Checking Continuity Between Terminals In Switch Position Table
    G03706724Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If the continuity is not as specified, replace the bulb (C) or the interior lights switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.