Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 181 (INTERIOR LIGHTS)GLOVE BOX LIGHT TEST/REPLACEMENT
2002 Honda Civic Si
Glove Box Light Test/Replacement
2002 Honda Civic SiSECTION Glove Box Light Test/Replacement
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the glove box (see LOWER GLOVE BOX REMOVAL/INSTALLATION ).
- Disconnect the 2P connector (A) from the glove box light (B).
Glove Box Light: 3.4 W
- Check for continuity between the No. 1 and No. 2 terminals.
- With the button (C) released, there should be continuity.
- With the button (C) pressed, there should be no continuity.
- If the continuity is not as specified, check the bulb (D). If the bulb is OK, replace the light.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.