SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 167 (HEATING/AIR CONDITIONING)RECEIVER/DRYER DESICCANT REPLACEMENT
2002 Honda Civic Si

Receiver/Dryer Desiccant Replacement

2002 Honda Civic SiSECTION Receiver/Dryer Desiccant Replacement
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Install the Receiver/Dryer as quickly as possible to prevent the system from absorbing moisture from the air.
  1. Remove the A/C condenser (see A/C COMPRESSOR RELIEF VALVE REPLACEMENT  ).
  2. Remove the cap (A) from the bottom of the A/C condenser. Remove the O-ring (B) and the desiccant (C).
    Fig 1: Removing Cap From Bottom Of A/C Condenser
    G03706389Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the receiver/dryer in the reverse order of removal, and note these items:
    • Replace the O-rings with new ones, and apply a thin coat of refrigerant oil (DENSO ND-OIL 8) before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
    • Install the cap to the specified torque. It is made of resin and can be easily stripped.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.