Sliding Door Panel Removal/Installation

Special Tools Required 

• KTC trim tool set SOJATP2014
• Trim pad remover, Snap-on A 177A or equivalent, commercially available

1. Open the sliding door as necessary.
2. Lower the glass fully.
3. Remove the power window switch panel (A).
   • -1 Pry on the rear edge of the switch panel with a trim tool to release the rear clip.
   • -2 Pull out along the edge of the panel to release the hooks (B).
   • -3 Disconnect the power window switch connector (C).
   Fig 1: Removing Power Window Switch Panel

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Use a wire hook to pull the clip (A) off the inner handle shaft (B), and remove the inner handle (C).
   Fig 2: Removing Inner Handle

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Release the sliding door sash inner trim as necessary (see SLIDING DOOR SASH INNER TRIM REPLACEMENT  ).
6. Use a clip remover (A) to release the clips that hold the door panel (B).
   Fig 3: Releasing Clips Holding Door Panel Using Clip Remover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Pull the door panel away from the inner handle shaft (C) and remove it.
8. If necessary, remove the screws, then remove the sliding door sunshade (A).
   Fig 4: Removing Sliding Door Sunshade

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
9. Install the door panel in the reverse order of removal, and note these items:
   • Make sure the switch connector is plugged in properly.
   • Check the clips for damage or stress-whitening, and replace them with new one.
   • Push the clips into place securely.