SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 119 (KEYLESS/POWER DOOR LOCKS/SECURITY SYSTEM)TRANSMITTER TEST
2002 Honda Civic Si

Transmitter Test

2002 Honda Civic SiSECTION Transmitter Test
WARNING: This page is about a different car, the 2006 Acura MDX, 2005 Acura MDX, 2004 Acura MDX, and 2003 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • To turn the remote DPMS feature ON or OFF, press and hold the LOCK and UNLOCK buttons of the transmitter. The transmitter LED will blink once for remote DPMS ON, and blink twice for remote DPMS OFF.
  • If the doors unlock or lock with the transmitter, but the LED on the transmitter does not come on, the LED is faulty; replace the transmitter.
  • If DPMS is in operable using the remote, make sure the DPMS feature is ON.
  • If any door is open, you cannot lock the door with the transmitter.
  • If you unlocked the doors with the transmitter, but do not open any of the doors within 30 seconds, the doors relock automatically.
  • The doors do not lock or unlock with the transmitter if the ignition key is inserted in the ignition switch.
  1. Press the lock or unlock button five or six times to reset the transmitter.
    • If the locks work, the transmitter is OK.
    • If the locks don't work, go to step 2.
  2. Open the transmitter and check for water damage.
    • If you find any water damage, replace the transmitter.
    • If there is no water damage, go to step 3.
  3. Replace the transmitter battery (A) with a new one, and try to lock and unlock the doors with the transmitter by pressing the lock or unlock button five or six times.
    • If the doors lock and unlock, the transmitter is OK.
    • If the doors don't lock and unlock, go to step 4.
      Fig 1: Replacing Transmitter Battery
      G03642383Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Reprogram and register the transmitter, then try to lock and unlock the doors.
    • If the doors lock and unlock, the transmitter is OK.
    • If the doors don't lock and unlock, replace the transmitter.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.