Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (POWER SLIDING DOOR SYSTEM)COMPONENT TESTSSLIDE MOTOR TESTLEFT SIDE
2002 Honda Civic Si
Left Side
2002 Honda Civic SiSECTION Left Side
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Honda Odyssey, 2003 Honda Odyssey, 2002 Honda Odyssey, 2001 Honda Odyssey, and 2000 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
- Remove left rear interior side trim panel. Disconnect sliding door motor 2-pin harness connector. Using fused jumper wires, connect battery voltage to sliding door motor harness connector terminal No. 1 (Black wire) and ground sliding door motor harness connector terminal No. 2 (Blue wire). See Figure. Sliding door should open. Go to next step.
- Using fused jumper wires, connect battery voltage to sliding door motor harness connector terminal No. 2 (Blue wire) and ground sliding door motor harness connector terminal No. 1 (Black wire). Sliding door should close. If sliding door does not operate as specified, replace sliding door motor and retest system. See SLIDING DOOR MOTOR UNIT under REMOVAL & INSTALLATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.