Procedure 6

Programming the Transmitter

NOTE:
Entering the programming mode cancels all learned transmitter codes, so none of the previously programmed transmitters will work. You must reprogram all the transmitters once you are in the programming mode.

1. Open the driver's door.

2. Press and hold the driver's door master power door lock switch up in the unlock position. (Continue to hold the switch during this procedure.)

3. Insert the key in the ignition switch and remove it. Repeat this four more times within 10 seconds, then leave the key in the switch. Check that the power door locks cycle to confirm that the system is in the programming mode. (This step must be completed within 10 seconds, or the system will exit the programming mode.)

4. Press the "LOCK" or "UNLOCK" button on the transmitter. Check that all power door locks (except the driver's) cycle to confirm that the transmitter's code was accepted by the system.

5. To program a second transmitter, press its "LOCK" or UNLOCK" button within 10 seconds of programming the first transmitter. (You can program two transmitters per vehicle.)

6. Release the master power door lock switch to exit the programming mode.

Ordering the Transmitter

Transmitters can be ordered only by authorized Honda Dealers. Order them from American Honda using normal parts ordering procedures.

Batteries for the Transmitter

The battery number is CR2016. Each transmitter uses two batteries.