Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1991ACCORD DX, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTPRE-ALIGNMENT CHECKSPRE-ALIGNMENT CHECKS
1991 Honda Accord DX, 2D Coupe, Automatic
Pre-Alignment Checks
1991 Honda Accord DX, 2D Coupe, AutomaticSECTION Pre-Alignment Checks
Before making wheel alignment adjustment, perform the following checks:
- Tires should be equal in size and runout must not be excessive. Tires and wheels should be in balance, and inflated to manufacturer's specifications.
- Wheel bearings must be properly adjusted. Steering linkage and suspension must not have excessive looseness. Check for wear in tie rod ends and ball joints.
- Steering gear box must not have excessive play. Check and adjust to manufacturer's specifications.
- Vehicle must be at curb height with full fuel load and spare tire in vehicle. No extra load should be on vehicle.
- Vehicle must be level with floor and with suspension settled. Jounce front and rear of vehicle several times and allow it to settle to normal curb height.
- If steering wheel is not centered with front wheels in straight-ahead position, correct by shortening one tie rod adjusting sleeve and lengthening opposite sleeve equal amounts.
- Ensure wheel lug nuts are tightened to torque specifications.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.