Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1984ACCORD L4-1829CC 1800 ES,ETREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION LOCKSERVICE AND REPAIR
1984 Honda Accord L4-1829cc 1800 ES,ET
Ignition Lock: Service and Repair
1984 Honda Accord L4-1829cc 1800 ES,ETSECTION Service and Repair
1. Remove lower steering column cover.
2. Disconnect ignition switch connector.
3. Center punch each of the two shear screw heads, then using a suitable drill and drill bit, remove screw heads and the switch.
4. Install new switch without ignition key inserted.
5. Hand tighten shear screws, insert ignition key, and check for proper operation of wheel lock.
6. Tighten shear screws until hex heads twist off.
7. Reconnect switch connector.
8. Position switch wiring and install lower steering column cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.