SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013YUKON DENALI AWD V8-6.2LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNTESTING AND INSPECTIONPROGRAMMING AND RELEARNING
2013 GMC Yukon Denali AWD V8-6.2L

Programming and Relearning

2013 GMC Yukon Denali AWD V8-6.2LSECTION Programming and Relearning



Power Tilt Steering Column Calibration

Tilt Soft Stops

After replacement of the memory seat module (MSM), tilt motor, or steering column, it is necessary to program the tilt soft stops. Each soft stop is a programmable end of travel that is set approximately 1.3 cm (0.5 in) from the mechanical end of travel. The steering column has a soft stop set at each end of the tilt up/down movement. The system uses soft stops to prevent wear on the system by ensuring that the steering column movement stops before it reaches its mechanical end of travel in any direction. The soft stops are initially programmed at the factory.

Tilt Soft Stop Programming Procedure

1. Ignition ON, Engine OFF.

2. Connect a scan tool to the vehicle.

3. Select Memory Seat Module.

4. Select Special Functions.

5. Select Driver Seat.

6. Select Learn Column Soft Stops.

7. Follow the scan tool on-screen instructions.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.