Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013YUKON DENALI AWD V8-6.2LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLTRAILER BRAKESTRAILER BRAKE CONTROL MODULETESTING AND INSPECTION
2013 GMC Yukon Denali AWD V8-6.2L
Trailer Brake Control Module: Testing and Inspection
2013 GMC Yukon Denali AWD V8-6.2LSECTION Testing and Inspection
Trailer Brake Control Module Programming and Setup
If the Trailer Brake Control Module or the combination Fuel Pump/Trailer Brake Control Module is replaced or needs to be reprogrammed, refer to Service Programming System (SPS) Service Programming System (SPS). The calibrations for either of these modules are accessed through the FPCM Fuel Pump Control Module selection in the supported controllers list. The Trailer Brake Control Module is not listed as a separate choice. Once the Fuel Pump Control Module is selected, the SPS system will download the proper calibration for the vehicle based on the VIN entered.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.