Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013YUKON DENALI AWD V8-6.2LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT TEMPERATURE SWITCHSERVICE AND REPAIR
2013 GMC Yukon Denali AWD V8-6.2L
Seat Temperature Switch: Service and Repair
2013 GMC Yukon Denali AWD V8-6.2LSECTION Service and Repair
Front Seat Heater Switch Replacement
Removal Procedure
1. Remove door upper trim panel. Refer to Upper Extension Trim Panel Replacement (Except Escalade) Upper Extension Trim Panel ReplacementUpper Extension Trim Panel Replacement (Escalade) Upper Extension Trim Panel Replacement.
2. Pull the door trim panel away from the door and support the bottom of the trim panel on the door panel hooks. Refer to Front Side Door Trim Panel Replacement Front Side Door Trim Panel Replacement.
3. Disconnect the electrical connector.
4. Remove the front side door heater switch fasteners (1).
5. Remove the front side door heater switch assembly (2).
Installation Procedure
1. Install the front side door heater switch assembly (2).
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the front side door heater switch fasteners and tighten to 2 Nm (18 lb in).
3. Connect the electrical connector.
4. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement Front Side Door Trim Panel Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.