Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013YUKON 2WD V8-5.3LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCAMSHAFT POSITION SENSORLOCATIONS
2013 GMC Yukon 2WD V8-5.3L
Camshaft Position Sensor: Locations
2013 GMC Yukon 2WD V8-5.3LSECTION Locations
Powertrain Component Views
Front and Left Side of Engine Components (except LZ1)
1 - Generator
2 - Manifold Absolute Pressure (MAP) Sensor
3 - Evaporative Emissions (EVAP) Canister Purge Solenoid Valve
4 - Ignition Coil 1
5 - Ignition Coil 3
6 - Ignition Coil 5
7 - Ignition Coil 7
8 - Engine Block Heater Connector (K05)
9 - Knock Sensor (KS) 1
10 - Engine Coolant Temperature (ECT) Sensor
11 - Camshaft Position (CMP) Sensor
12 - A/C Compressor Clutch
13 - Throttle Body
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.