Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013TERRAIN FWD L4-2.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSSUSPENSIONBALL JOINT
2013 GMC Terrain FWD L4-2.4L
Ball Joint
2013 GMC Terrain FWD L4-2.4LSECTION Ball Joint
Clean and inspect the ball joint seal for cuts or tears. If the ball joint seal is damaged, replace the ball joint.
Support the lower control arm with a floor stand as far outboard as possible and raise the suspension to just below ride height.
If the dial indicator indicates a reading greater than 0.5 mm (0.02 in), replace the ball joint.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.