Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013TERRAIN AWD L4-2.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECAMSHAFT GEAR/SPROCKET
2013 GMC Terrain AWD L4-2.4L
Camshaft Gear/Sprocket
2013 GMC Terrain AWD L4-2.4LSECTION Camshaft Gear/Sprocket
Install EN-48953 - locking tool (1) and tighten the bolts into the cylinder head to 10 Nm (89 lb in).
Using a torque wrench, tighten the intake camshaft actuator bolt to 30 Nm (22 lb ft), plus 100 degrees using the EN 45059 - meter.
Using a torque wrench, tighten the exhaust camshaft actuator bolt to 30 Nm (22 lb ft), plus 100 degrees using the EN 45059 - meter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.