Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SIERRA DENALI AWD V8-6.2LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRBODY SIDE WINDOW REPLACEMENT
2013 GMC Sierra Denali AWD V8-6.2L
Body Side Window Replacement
2013 GMC Sierra Denali AWD V8-6.2LSECTION Body Side Window Replacement
Body Side Window Replacement
Removal Procedure
1. Place tape from body side to window to hold in place.
2. Remove the side access door trim panel. Refer to Rear Side Access Door Trim Panel Replacement Rear Side Access Door Trim Panel Replacement.
3. Disconnect the window latch.
4. Remove the bolts from the hinges.
5. Remove the tape and window from the vehicle.
Installation Procedure
1. Position the window and tape into position.
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the bolts to the hinges.
Tighten the bolts to 10 Nm (89 lb in).
3. Install the window latch.
4. Remove the tape and inspect the window.
5. Install the side access door trim panel. Refer to Rear Side Access Door Trim Panel Replacement Rear Side Access Door Trim Panel Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.