Air Conditioning Cycling Switch Replacement

2013 GMC Sierra Denali AWD V8-6.2LSECTION Air Conditioning Cycling Switch Replacement



Air Conditioning Cycling Switch Replacement (Non-HP2)

Special Tools

J-39400-A - Halogen Leak Detector

Removal Procedure

1. Disconnect the electrical connector from the A/C low pressure switch.




2. Remove the A/C low pressure switch from the accumulator.

3. Remove the O-ring and discard.

Installation Procedure

1. Install the new O-ring seal to the switch. Refer to Air Conditioning O-Ring Seal Replacement Air Conditioning O-Ring Seal Replacement.





Caution: Refer to Fastener Caution Fastener Caution.

2. Install the A/C low pressure switch to the accumulator and tighten to 6 Nm (53 lb in).

3. Connect the electrical connector to the A/C low pressure switch.

4. Leak test the fittings of the components using theJ-39400-A - halogen leak detector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.