Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SIERRA DENALI 2WD V8-6.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCRANKSHAFT POSITION SENSORSERVICE AND REPAIR
2013 GMC Sierra Denali 2WD V8-6.2L
Crankshaft Position Sensor: Service and Repair
2013 GMC Sierra Denali 2WD V8-6.2LSECTION Service and Repair
Crankshaft Position Sensor Replacement
Removal Procedure
Note:
Perform the Crankshaft Position System Variation Learn Testing and Inspection whenever the crankshaft position sensor is removed or replaced.
1. Remove the starter. Refer to Starter Replacement (Diesel) Service and RepairStarter Replacement (V6) Service and RepairStarter Replacement (V8) Service and Repair.
2. Working through the wheel well opening, disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
4. Remove the CKP sensor bolt.
5. Remove the CKP sensor.
Installation Procedure
1. Install the CKP sensor.
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the CKP sensor bolt.
Tighten the bolt to 25 Nm (18 lb ft).
3. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
4. Install the starter. Refer to Starter Replacement (Diesel) Service and RepairStarter Replacement (V6) Service and RepairStarter Replacement (V8) Service and Repair.
5. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn Testing and Inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.