Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SIERRA 3500 DENALI 2WD V8-6.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR FLOW METER/SENSORLOCATIONS
2013 GMC Sierra 3500 Denali 2WD V8-6.0L
Air Flow Meter/Sensor: Locations
2013 GMC Sierra 3500 Denali 2WD V8-6.0LSECTION Locations
Front of Vehicle/Engine Compartment Component Views
Right Rear of the Engine Compartment Components (4.8L, 5.3L, 6.0L or 6.2L except HP2)
1 - Fuse Holder
2 - Battery - Right
3 - A/C Compressor Clutch (C67 or CJ2)
4 - A/C Refrigerant Pressure Sensor (C67 or CJ2)
5 - Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.