Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SIERRA 2500 4WD V8-6.6L DSL TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESENGINE SPEED POWER TAKE-OFF CONTROL MODULE SCAN TOOL INFORMATION
2013 GMC Sierra 2500 4WD V8-6.6L DSL Turbo
Engine Speed Power Take-Off Control Module Scan Tool Information
2013 GMC Sierra 2500 4WD V8-6.6L DSL TurboSECTION Engine Speed Power Take-Off Control Module Scan Tool Information
Engine Speed Power Take-Off Control Module Scan Tool Information
The scan tool data lists contain all of the power take-off (PTO) related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The data list column indicates the location of the parameter within the scan tool menu selections.
Use the scan tool data lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with Diagnostic System Check - Vehicle.
Use the scan tool data lists only after the following is determined:
* There is no published DTC procedure or published symptom procedure for the customer concern.
* The DTC or symptom procedure indicated by the diagnostic system check does not resolve the customer concern.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.