Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SIERRA 2500 2WD V8-6.6L DSL TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORLOCATIONS
2013 GMC Sierra 2500 2WD V8-6.6L DSL Turbo
Camshaft Position Sensor: Locations
2013 GMC Sierra 2500 2WD V8-6.6L DSL TurboSECTION Locations
Powertrain Component Views
Right Front Side of the Engine Components (Diesel)
1 - Fuel Injector 3
2 - Fuel Filter Pressure Switch
3 - Intake Air Heater
4 - Intake Air Valve
5 - Generator - Auxiliary
6 - Camshaft Position (CMP) Sensor
7 - Crankshaft Position (CKP) Sensor
8 - Glow Plug Control Module
9 - Glow Plug 1
10 - Fuel Injector 1
11 - Glow Plug 3
12 - Starter Motor
13 - Water in Fuel Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.