Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SAVANA 3500 V8-6.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONFUEL PUMPSERVICE AND REPAIRFUEL PUMP FLOW CONTROL MODULE REPLACEMENT
2013 GMC Savana 3500 V8-6.0L
Fuel Pump Flow Control Module Replacement
2013 GMC Savana 3500 V8-6.0LSECTION Fuel Pump Flow Control Module Replacement
Fuel Pump Flow Control Module Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Disconnect the chassis wiring harness electrical connector (2) from the fuel pump flow control module (1).
3. Remove the fuel pump flow control module bolts (1).
4. Remove the fuel pump flow control module (2) from the frame.
Installation Procedure
1. Place the fuel pump flow control module (2) against the frame.
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the fuel pump flow control module bolts (1) and tighten to 9 Nm (80 lb in).
3. Connect the chassis wiring harness electrical connector (1) to the fuel pump flow control module (2).
4. Lower the vehicle.
5. Program the fuel pump flow control module. Refer to Control Module References Control Module References.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.