Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SAVANA 3500 V8-6.0LREPAIR AND DIAGNOSISBODY AND FRAMEFRAMECROSS-MEMBERSERVICE AND REPAIRENGINE FRONT CROSSMEMBER REPLACEMENT (RWD)
2013 GMC Savana 3500 V8-6.0L
Engine Front Crossmember Replacement (RWD)
2013 GMC Savana 3500 V8-6.0LSECTION Engine Front Crossmember Replacement (RWD)
Engine Front Crossmember Replacement (RWD)
Removal Procedure
1.Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2.Disconnect the electrical wiring harness connectors from the engine crossmember.
3.Remove the engine crossmember mounting bolts.
4.Remove the engine crossmember.
Installation Procedure
1.Install the engine crossmember.
Caution:Refer to Fastener Caution .
2.Install the engine crossmember mounting bolts.
-LD 14,200 lb GVW, tighten the bolts to120 N �m (89 lb ft).
-CA 14,200 lb GVW, tighten the bolts to85 N �m (63 lb ft) plus 90 degrees.
-HD and CA, tighten the bolts to135 N �m (100 lb ft)
3.Connect the electrical wiring harness connectors to the engine crossmember.
4.Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.