Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SAVANA 2500 V8-4.8LREPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERSERVICE AND REPAIR
2013 GMC Savana 2500 V8-4.8L
Front Fender: Service and Repair
2013 GMC Savana 2500 V8-4.8LSECTION Service and Repair
Upper Front Fender Filler Panel Replacement
Removal Procedure
1.Place a protective covering at the top of the fender.
2.Remove the upper fender filler panel applique. Refer to Windshield Frame Filler Panel Applique Replacement .
3.Remove the bolt (4) retaining the upper filler panel (1) to the body.
4.Remove the upper filler panel (1) from the retaining clips.
5.Remove the upper filler panel (1) from the vehicle.
Installation Procedure
1.Install the upper fender filler panel (1) to the vehicle.
2.Install the upper fender filler panel (1) under the windshield molding.
Install the upper fender filler panel (1) onto the retaining clips.
Caution:Refer to Fastener Caution .
3.Install the bolt (4) in order to retain the upper fender filler panel (1) to the body and tighten to2 N �m (18 lb in).
4.Install the upper fender filler panel applique. Refer to Windshield Frame Filler Panel Applique Replacement .
5.Remove the protective covering from the fender.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.