Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SAVANA 1500 AWD V8-5.3LREPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSAIR BAG CONTROL MODULETESTING AND INSPECTION
2013 GMC Savana 1500 AWD V8-5.3L
Air Bag Control Module: Testing and Inspection
2013 GMC Savana 1500 AWD V8-5.3LSECTION Testing and Inspection
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Note:
The air bag indicator light may remain ON after the body control module (BCM), or inflatable restraint sensing and diagnostic module (SDM) is replaced, and during the programming procedure for the BCM until after the procedure is completed. When installing a new SDM, there may be several DTCs set prior to programming. Once programmed, these DTCs should be in history and can be cleared. If both the rollover sensor and the SDM are replaced at the same time, perform Inflatable Restraint Vehicle Rollover Sensor Programming and Setup Testing and Inspection first.
1. If DTC B0090 is set, refer to DTC B0090 B0090.
2. Ignition ON, program the SDM. Refer to Service Programming System (SPS) Service Programming System (SPS).
3. In the BCM Module Setup menu, select Setup SDM Primary Key in BCM. Follow the scan tool on screen instructions.
4. In the SDM Module Setup menu, select Setup SDM. Follow the scan tool on screen instructions.
5. Cycle the ignition from OFF to ON. Verify no DTCs are set. If any DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.