Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TRANSIT CONNECT L4-2.0LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLETRANSMISSION MOUNTSERVICE AND REPAIRTRANSAXLE SUPPORT INSULATOR
2012 Ford Transit Connect L4-2.0L
Transaxle Support Insulator
2012 Ford Transit Connect L4-2.0LSECTION Transaxle Support Insulator
Transaxle Support Insulator
Transaxle Support Insulator
Removal
1. Remove the battery and battery tray.
2. Install the Engine Support Bar, Engine Lifting Bracket and Adapters and support the engine.
3. Remove the transaxle support insulator nuts and remove the transaxle support insulator.
Installation
1. Install the transaxle support insulator nuts.
- Install the 4 transaxle support insulator-to-body nuts.
- Tighten to 48 Nm (35 lb-ft).
- Install the transaxle support insulator-to-bracket nut.
- Tighten to 150 Nm (111 lb-ft).
2. Remove the Engine Support Bar, Engine Lifting Bracket and Adapters and support the engine.
3. Install the battery tray and battery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.