Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TRANSIT CONNECT L4-2.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONAIR FLOW METER/SENSORFUEL CUT-OUT SWITCHSERVICE AND REPAIR
2012 Ford Transit Connect L4-2.0L
Fuel Cut-Out Switch: Service and Repair
2012 Ford Transit Connect L4-2.0LSECTION Service and Repair
Inertia Fuel Shutoff (IFS) Switch
Removal and Installation
1. Remove the RF lower cowl trim panel.
2. Disconnect the Inertia Fuel Shutoff (IFS) switch electrical connector.
3. NOTICE: Do not overtighten the fasteners or damage to the switch will occur.
Remove the 2 bolts and the IFS (Inertia Fuel Shutoff) switch.
- To install, tighten to 2 Nm (18 lb-in).
4. To install, reverse the removal procedure.
- If necessary, reset the IFS (Inertia Fuel Shutoff) switch after the installation has been completed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.