SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TRANSIT CONNECT L4-2.0LREPAIR AND DIAGNOSISLIGHTING AND HORNSFOG/DRIVING LAMPADJUSTMENTS
2012 Ford Transit Connect L4-2.0L

Fog/Driving Lamp: Adjustments

2012 Ford Transit Connect L4-2.0LSECTION Adjustments



Front Fog Lamp Adjustment

1. NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
Before starting the fog lamp assembly adjustment:

- check the tire inflation.

- make sure there are no other loads in the vehicle other than a half tank of fuel.

- make sure the vehicle is on level ground.

- make sure the fog lamps and headlamps are clean.

- make sure the headlamps are operating and are correctly aimed.


2. NOTE: The vertical wall screen must be a minimum of 2.4 m (8 ft) wide.
Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.






3. The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 10 cm (4 in) below the horizontal center of the fog lamps.




RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.