Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TRANSIT CONNECT L4-2.0LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE PADTESTING AND INSPECTION
2012 Ford Transit Connect L4-2.0L
Brake Pad: Testing and Inspection
2012 Ford Transit Connect L4-2.0LSECTION Testing and Inspection
Brake System Inspection
Brake Pads
NOTE: It is not required to install new brake pads when the brake discs are machined.
1. Inspect and measure the thickness of the brake pad friction material. For additional information, refer to Specifications.
- Minor surface cracks do not require pad replacement, however, if there are missing chunks or cracks in the lining through to the backing plate, install new brake pads.
- If the thickness of the friction material is less than the specified thickness, install new brake pads. for front disc brakes.
- If the friction material shows taper wear that is not within specifications, install new brake pads and verify the caliper guide pins are functioning correctly. For additional information, refer to Brake Caliper Guide Pins inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.