Interior Rear View Mirror

Interior Rear View Mirror





Mirror Identification









Removal

Mirror Type 1

NOTICE: The windshield must be at room temperature. Otherwise, damage to the windshield glass may occur.

1. If equipped.





2.





3. NOTICE: Make sure the Mirror Remover is fully inserted into the interior rear view mirror mount access hole. Otherwise, damage to the windshield glass may occur.






4. Using a closed hand, bump the adjustment handle of the Mirror Remover to slide the mirror upward on the mirror mount.





5.





Mirror Type 2

6.





Mirror Type 3

7.





8.





9.





Mirror Type 4

10.





11.





12. NOTICE: To prevent damage to the mirror or base, rotate the mirror base with hands only do not use tools.

NOTICE: To prevent damage to the mirror wiring, do not rotate the mirror head beyond 180 degrees.






Installation

Mirror Type 1

1. Slide the interior rear view mirror mount over the windshield bracket from the top.





2. NOTE: An audible click will be heard as the mirror fully seats.






3. If equipped.





4. If equipped with compass module, check the compass zone and calibration. Refer to General Procedures in Instrument Panel, Gauges and Warning Indicators or Compass.

Mirror Type 2

5.





6. If equipped with a compass module which requires calibration, check the compass zone adjustment and calibration. Refer to General Procedures in Instrument Panel, Gauges and Warning Indicators or Compass.

Mirror Type 3

7. To install, reverse the removal procedure.

Mirror Type 4

8. To install, reverse the removal procedure.
- If a new mirror has been installed, download the IPM-A (Image Processing Module - A) configuration information from the scan tool to the new IPM-A (Image Processing Module - A).

- If a new mirror has been installed, perform camera alignment using a scan tool.