Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TRANSIT CONNECT L4-2.0LREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMCONSOLESERVICE AND REPAIRCONSOLE - OVERHEAD
2012 Ford Transit Connect L4-2.0L
Console - Overhead
2012 Ford Transit Connect L4-2.0LSECTION Console - Overhead
Console - Overhead
Removal and Installation
1. NOTICE: When prying on a component, a non-marring tool must be used or damage to the component may occur.
Remove the front dome lamp.
1. With a non-marring tool, pry the front dome lamp downward to release from the headliner.
2. Disconnect the electrical connector.
2. If equipped, remove the SYNC(R) microphone.
3. Remove the LH and RH sun visors and the sun visor clips.
4. Remove the overhead console screws and bolts.
1. Remove the 2 front screws through the front dome lamp opening.
2. Remove the 2 front bolts through the sun visor mounting openings.
3. Remove the 2 overhead console cargo net bracket bolts.
4. NOTICE: To avoid damaging the overhead console, an assistant is required to support the instrument panel when carrying out this step.
Remove the 2 rear bolts and the overhead console.
5. To install, reverse the removal procedure.
- To install, make sure to align the guide pin to the adjacent hole.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.