Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TRANSIT CONNECT L4-2.0LREPAIR AND DIAGNOSISBODY AND FRAMEBUMPERREAR BUMPERSERVICE AND REPAIR
2012 Ford Transit Connect L4-2.0L
Rear Bumper: Service and Repair
2012 Ford Transit Connect L4-2.0LSECTION Service and Repair
Bumper - Rear
Removal and Installation
1. Remove the rear bumper side cover star washers (1 each side).
2. Pull outward on the rear bumper side covers to release the pin-type retainers from the body.
3. Remove the rear bumper nuts.
- To install, tighten to 36 Nm (27 lb-ft).
4. Remove the rear bumper.
- If equipped, disconnect the rear parking aid sensor electrical connectors.
5. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.