Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TAURUS FWD V6-3.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYTESTING AND INSPECTIONPINPOINT TESTS
2012 Ford Taurus FWD V6-3.5L
Pinpoint Tests
2012 Ford Taurus FWD V6-3.5LSECTION Pinpoint Tests
Pinpoint Test
Pinpoint Test A: Battery Condition Test
Normal Operation
Battery condition is determined by measuring battery terminal voltage after a specific discharge current is applied for a specified time period.
This pinpoint test is intended to diagnose the following:
- Battery charge
- Battery
PINPOINT TEST A : BATTERY CONDITION TEST
A1 TEST THE BATTERY CONDITION
NOTE: A red test-eye indicates the battery is discharged, not necessarily defective.
NOTE: Failure to fully charge the battery before retesting may cause false readings.
- Verify the battery condition using the Intelligent Diagnostic Charger.
Is the battery OK?
Yes
RETURN the battery to service.
No
If the analyzer reads REPLACE BATTERY or REPLACE-BAD CELL, INSTALL a new battery. REFER to Battery .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.