Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TAURUS FWD V6-3.5LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSAUTOMATIC TRANSMISSION/TRANSAXLESYSTEM SPECIFICATIONSAUTOMATIC TRANSMISSION - 6F50/6F55
2012 Ford Taurus FWD V6-3.5L
Automatic Transmission - 6F50/6F55
2012 Ford Taurus FWD V6-3.5LSECTION Automatic Transmission - 6F50/6F55
General Specifications
Solenoid Operation Chart
CB = Clutch brake
NC = Normally closed
NH = Normally high
NL = Normally low
a Turns on above 8 km/h (5 mph).
b Turns off above 8 km/h (5 mph).
Clutch Application Chart
O/R = Overrunning
Line Pressure Chart
a All pressures are approximate.
Stall Speed Chart
Gear Ratio Chart
Shift Speeds
Differential Bearing Preload Shim Selection Chart
Transfer Gear Bearing Preload Shim Selection Chart
Torque Specifications
a Refer to the procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.