Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Camshaft Position Sensor: Service and Repair
2012 Ford Taurus AWD V6-3.5LSECTION Service and Repair
Camshaft Position (CMP) Sensor - 3.5L
Removal and Installation
1. Remove the Air Cleaner (ACL) outlet pipe and the ACL (Air Cleaner).
2. Disconnect the Camshaft Position (CMP) sensor electrical connector.
3. Remove the bolt and the CMP (Camshaft Position) sensor.
- To install, tighten to 10 Nm (89 lb-in).
4. NOTE: Lubricate the CMP (Camshaft Position) sensor O-ring seal with clean engine oil.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.