Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TAURUS AWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSMARKER LAMPSERVICE AND REPAIR
2012 Ford Taurus AWD V6-3.5L
Marker Lamp: Service and Repair
2012 Ford Taurus AWD V6-3.5LSECTION Service and Repair
Side Lamp/Front Turn Signal Lamp Bulb
Front Turn Signal Lamp
NOTE: The headlamp is shown removed for clarity.
Front Side Marker Lamp
Removal and Installation
Front park/turn lamp
1. For the LH front park/turn lamp, squeeze the tabs and remove the hood switch.
- Disconnect the electrical connector.
Side marker lamp
2. Remove the 3 screws and position the fender splash shield aside.
Any lamp
3. Rotate the bulb holder approximately one-eighth turn counterclockwise and remove it from the headlamp assembly.
- Disconnect the electrical connector.
- If necessary, remove the bulb from the holder.
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.