Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012TAURUS AWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSBACKUP LAMPSERVICE AND REPAIRREVERSING LAMP
2012 Ford Taurus AWD V6-3.5L
Reversing Lamp
2012 Ford Taurus AWD V6-3.5LSECTION Reversing Lamp
Reversing Lamp
Removal and Installation
1. Remove the 2 push-pins and position the luggage compartment lid trim panel aside.
2. NOTE: Make sure to take note where each reversing lamp bracket mounts to on the reversing lamp. They are not interchangeable.
Remove the 2 nuts and the reversing lamp brackets.
3. Separate the luggage compartment trim panel moulding and remove the reversing lamp.
4. NOTE: Make sure the outboard lip of the reversing lamp is correctly installed over the luggage compartment lid. This provides the necessary holding force for the reversing lamp brackets to retain the reversing lamp to the luggage compartment lid.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.