Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012MUSTANG V6-3.7LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRSTEERING COLUMN COUPLING
2012 Ford Mustang V6-3.7L
Steering Column Coupling
2012 Ford Mustang V6-3.7LSECTION Steering Column Coupling
Steering Column Coupling
Removal and Installation
NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected or damage to the clockspring may result. If there is evidence that the steering column shaft has rotated, the clockspring must be removed and recentered. For additional information, refer to Restraints and Safety Systems &/or Air Bag Systems.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Place the steering wheel in the straight-ahead position and turn the ignition switch to the OFF position.
3. Remove and discard the lower steering column shaft-to-steering column coupling bolt.
- To install, tighten the new bolt to 47 Nm (35 lb-ft).
4. Remove and discard the steering column coupling-to-steering gear bolt.
- To install, tighten the new bolt to 25 Nm (18 lb-ft).
5. Remove the 2 dash boot bearing nuts.
- To install, tighten to 9 Nm (80 lb-in).
6. Collapse the upper steering column shaft slightly and disconnect the lower steering column shaft from the steering column coupling.
7. Remove the steering column coupling.
8. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.