Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION FWD L4-2.5LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINMANUAL TRANSMISSION/TRANSAXLETRANSMISSION SPEED SENSORSERVICE AND REPAIR
2012 Ford Fusion FWD L4-2.5L
Transmission Speed Sensor: Service and Repair
2012 Ford Fusion FWD L4-2.5LSECTION Service and Repair
Vehicle Speed Sensor (VSS)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the Vehicle Speed Sensor (VSS) electrical connector.
3. Remove the VSS (Vehicle Speed Sensor) bolt.
- To install, tighten to 9 Nm (80 lb-in).
4. Remove the VSS (Vehicle Speed Sensor).
- Discard the O-ring.
5. To install, reverse the removal procedure.
- Apply clean manual transaxle fluid to a new O-ring and install it on the VSS (Vehicle Speed Sensor).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.