Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION FWD L4-2.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSMARKER LAMPSERVICE AND REPAIR
2012 Ford Fusion FWD L4-2.5L
Marker Lamp: Service and Repair
2012 Ford Fusion FWD L4-2.5LSECTION Service and Repair
Side Marker Lamp - Front
Fusion
MKZ
Removal and Installation
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 pin-type retainers and position the fender splash shield aside.
3. Disconnect the side marker lamp electrical connector.
Fusion
4. Remove the nut and remove the side marker lamp.
MKZ
5. Remove the side marker lamp from the headlamp assembly.
All vehicles
6. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.