Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION FWD L4-2.5LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSTRUNK / LIFTGATE LOCK CYLINDERSERVICE AND REPAIR
2012 Ford Fusion FWD L4-2.5L
Trunk / Liftgate Lock Cylinder: Service and Repair
2012 Ford Fusion FWD L4-2.5LSECTION Service and Repair
Luggage Compartment Lid Lock Cylinder
Removal and Installation
1. Remove the 10 pin-type retainers and the luggage compartment lid trim panel.
2. Disconnect the luggage compartment lid lock cylinder actuating cable from the luggage compartment lid lock cylinder.
3. If equipped, disconnect the electrical connector from the luggage compartment anti-theft inhibit switch.
4. Remove the 2 rivets and the luggage compartment lid lock cylinder.
5. To install, reverse the removal procedure.
- Use the special tool to install new rivets.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.