Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION FWD L4-2.5LREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMCONSOLESERVICE AND REPAIR
2012 Ford Fusion FWD L4-2.5L
Console: Service and Repair
2012 Ford Fusion FWD L4-2.5LSECTION Service and Repair
Console - Overhead
Removal and Installation
NOTE: Fusion shown, MKZ similar.
1. Open the overhead console compartment door.
2. From inside the compartment, remove the 2 screws.
3. Remove the overhead console.
- Disconnect the electrical connectors.
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.