SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION FWD L4-2.5LREPAIR AND DIAGNOSISBODY AND FRAMEDESCRIPTION AND OPERATIONSUBFRAME AND MOUNTING SYSTEMS
2012 Ford Fusion FWD L4-2.5L

Subframe and Mounting Systems

2012 Ford Fusion FWD L4-2.5LSECTION Subframe and Mounting Systems



Subframe and Mounting Systems

Front Subframe

The front subframe is bolted to the body and is used to:

- aid in structural support.
- provide mounting surfaces for the front suspension control arms.
- provide a mounting point for the engine isolators.
- provide the mounting surface for the steering gear.
- provide the mounting surface for the sway bar.

Rear Subframe

The rear subframe is bolted to the body and is used to:

- aid in structural support.
- provide the mounting surface for the rear suspension upper control arms, rear suspension lower control arms and (if equipped) a mounting location for the rear differential.

Underbody misalignment can affect front and rear wheel alignment, the operation of the suspension parts and drivetrain operation. Door and window opening concerns and air or water leaks at the doors are often caused by incorrectly tightened bolts and body misalignment. For information on underbody dimensions, refer to Body Repairs.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.