Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test AR: DTC U3003:17 (Accessory Protocol Interface Module (APIM) )
2012 Ford Fusion FWD L4-2.5LSECTION Pinpoint Test AR: DTC U3003:17 (Accessory Protocol Interface Module (APIM) )
Information and Entertainment System
Pinpoint Test AR: DTC U3003:17 (Accessory Protocol Interface Module (APIM))
Normal Operation
- DTC U3003:17 (Battery Voltage: Circuit Voltage Above Threshold)- set by the Accessory Protocol Interface Module (APIM) when the supply voltage is greater than 15.8 volts for more than 250 milliseconds during normal operation.
This pinpoint test is intended to diagnose the following:
- Charging system concern
- APIM (Accessory Protocol Interface Module)
PINPOINT TEST AR : DTC U3003:17 (APIM (Accessory Protocol Interface Module))
NOTE: DTC U3003:17 may be stored in the module memory due to past battery charging or vehicle jump starting events.
AR1 CHECK FOR HIGH VOLTAGE DTCs SET IN OTHER MODULES
- Ignition ON.
- Retrieve the continuous DTCs from all modules.
Is DTC B1317, B1676, B0563 (PCM), or U3003:17 set in more than one module?
Yes
REFER to Charging System to diagnose an overcharging condition.
No
GO to AR2.
AR2 CHECK THE BATTERY VOLTAGE
- Turn off all interior/exterior lights and accessories.
- Start and run the engine at approximately 2,000 rpm for 3 minutes while monitoring the battery voltage.
Does the battery voltage rise to 15.5 volts or higher?
Yes
REFER to Charging System to diagnose an overcharging condition.
No
GO to AR3.
AR3 RECHECK FOR DTC B1317
- Ignition OFF.
- Ignition ON.
- Clear the APIM (Accessory Protocol Interface Module) DTCs.
- Repeat the APIM (Accessory Protocol Interface Module) self-test.
Is DTC U3003:17 present?
Yes
INSTALL a new APIM (Accessory Protocol Interface Module). REFER to Accessory Protocol Interface Module (APIM) . TEST this system for normal operation.
No
The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.