Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Crankshaft Position Sensor: Service and Repair
2012 Ford Fusion AWD V6-3.5LSECTION Service and Repair
Crankshaft Position (CKP) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the LH catalytic converter.
3. Remove the bolt, nut and the heat shield.
- To install, tighten to 10 Nm (89 lb-in).
4. Remove the rubber grommet cover.
5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
6. Remove the bolt and the CKP (Crankshaft Position) sensor.
- To install, tighten to 10 Nm (89 lb-in).
7. To install, reverse the removal procedure.
8. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.