Fog/Driving Lamp: Service and Repair

Fog Lamp

Fusion










MKZ









Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

All vehicles

1. With the vehicle in NEUTRAL, position it on a hoist.

Fusion

2. Remove the 2 outer screws and the 4 front screws from the lower radiator air deflector.

3. Remove the 4 pin-type retainers and the lower radiator air deflector.

All vehicles

4. NOTE: For MKZ, the fog lamp bezel tabs are located along the upper and lower edge close to each corner. They are released from the front using a thin flat-bladed tool (such as a pocket screwdriver). Use care not to damage the painted surface when releasing the tabs.
Release the 4 tabs and remove the fog lamp bezel.


5. Release the locking tabs and remove the fog lamp.
- Disconnect the electrical connector.


6. To install, reverse the removal procedure.