Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION AWD V6-3.5LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE ROTOR/DISCSERVICE AND REPAIRBRAKE DISC SHIELD
2012 Ford Fusion AWD V6-3.5L
Brake Disc Shield
2012 Ford Fusion AWD V6-3.5LSECTION Brake Disc Shield
Brake Disc Shield - All Wheel Drive (AWD)
Removal
1. Remove the wheel bearing and wheel hub.
2. Index-mark the brake disc shield to the wheel knuckle.
3. Cut the brake disc shield and remove it from the wheel knuckle.
Installation
1. Transfer the index mark from the removed brake disc shield to the new brake disc shield.
2. Position the brake disc shield onto the wheel knuckle.
3. Align the index marks and install the brake disc shield onto the wheel knuckle using the Front Subframe Bushing Remover/Installer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.