Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION AWD V6-3.0L FLEX FUELREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONALIGNMENTSERVICE AND REPAIRTOE ADJUSTMENT - REAR
2012 Ford Fusion AWD V6-3.0L Flex Fuel
Toe Adjustment - Rear
2012 Ford Fusion AWD V6-3.0L Flex FuelSECTION Toe Adjustment - Rear
Toe Adjustment - Rear
1. Using alignment equipment and the manufacturer's instructions, measure the rear toe.
2. Loosen the toe link jam nuts.
3. Rotate the toe link adjusting rod until the toe setting is within specifications.
4. NOTE: Do not allow the adjusting rod to rotate while tightening the jam nuts.
Tighten the toe link jam nuts to 102 Nm (75 lb-ft).
5. Recheck the rear toe and adjust as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.