Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION AWD V6-3.0L FLEX FUELREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGHEATER CORESERVICE AND REPAIR
2012 Ford Fusion AWD V6-3.0L Flex Fuel
Heater Core: Service and Repair
2012 Ford Fusion AWD V6-3.0L Flex FuelSECTION Service and Repair
Heater Core
Removal and Installation
NOTE: If a heater core leak is suspected, the heater core must be pressure leak tested before it is removed from the vehicle.
1. Remove the heater core and evaporator core housing. For additional information, refer to Heater Core And Evaporator Core Housing .
2. Detach the wire harness from the heater core cover.
3. Remove the 8 heater core cover screws.
4. Remove the heater core cover.
5. Remove the dash panel seal from the heater core tubes.
6. Remove the heater core.
7. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.